On 2/25/21 6:55 PM, AvantGuard Systems wrote:
Steve, I found the mComm 2.5. It's for Windows. I see.... It's install
program is called Setup250.exe!
Ok, I have a Windows computer I can use. But maybe the linux one will
work as well.
On linux you would use the python version of mComm, or dlplus, or
LaddieAlpha since it does run with mono.
I personally use dlplus on linux, but I will probably switch over to
python mComm sooner or later because the python version can be made
fully cross-platform more easily, and python is easier to hack on. It
already is cross-platform, but I mean even with nice user-friendly
packaging.
> Any additional instructions for getting the ModelT to connect to the
> computer running mcomm?
This is how you connect it:
http://tandy.wiki/Model_T_Serial_Cable
That is the entire directions is just, ensure you have the right wiring
in the serial cable, and these are several known-good cables you can buy
already made, or follow that table to make your own, though the parts
cost more than a full pre-made cable does.
--
bkw
