I’m sorry, but I do not understand your questions … in particular what is meant
by “dumping of equations”. Please state your question carefully and precisely
and be sure to give enough information so we can understand what you are asking.
Ray
> On Feb 14, 2016, at 10:43 AM, Mounika Vanjarapu <[email protected]>
> wrote:
>
> actually i am doing my project on "congestion management using demand
> response".in order to implement that there are lot of equations regarding
> load demand after implementing demand response including price elasticity of
> demand.my sir told that dumping of equations in matlab and doing this project
> in 5 months is somewhat difficult.so i require advice regarding this ,can we
> do without dumping of equations.or i goto other software.
>
> On Sun, Feb 14, 2016 at 8:36 PM, Abhyankar, Shrirang G. <[email protected]
> <mailto:[email protected]>> wrote:
> Please ALWAYS send the code you were trying to run and the entire error
> message.
>
> Shri
>
> On Feb 13, 2016, at 11:16 PM, Mounika Vanjarapu <[email protected]
> <mailto:[email protected]>> wrote:
>
>> when i tried for case9 or case5 ,its getting error.what is the reason
>>
>> On Wed, Feb 10, 2016 at 6:29 PM, Mounika Vanjarapu
>> <[email protected] <mailto:[email protected]>> wrote:
>> thanq very much for answering.
>>
>> On Wed, Feb 10, 2016 at 3:46 AM, Mirish Thakur <[email protected]
>> <mailto:[email protected]>> wrote:
>> Hello Mounika,
>>
>> If I'm not wrong are you interested in this one -
>> mpc=case_ieee30; % load case_ieee30
>> mpc1=load2disp(mpc); % make all loads dispatchable
>> r=runopf(mpc1); % perform opf operation on mpc1 casefile.
>> You can observe all loads are modeled as negative generators in mpc1.gen
>> matrix.
>> In r.gen(:,2) field you will see all dispatchable loads. But now I can see
>> 283.4 of 283.4 dispatchable loads. I think its because of no congestion in
>> network and generation is suffice to meet demand.
>>
>> Thanks and regards
>> Mirish
>>
>>
>>
>> On Tue, Feb 9, 2016 at 6:17 PM, Mounika Vanjarapu
>> <[email protected] <mailto:[email protected]>> wrote:
>> sir i dont know basics in matpower.i want to know how to write the code for
>> converting fixed loads to dispatchable loads taking a small example.for
>> example an ieee 30 bus taking some are dispatchable.
>>
>>
>>
>
