"Foreshew, Michael, HiServ/AU" wrote:
>
>
> I just got a couple of spiggot bushes for the L18 ($5 from Repco as
> opposed to $17 from Nissan). Does any body have any tips on
> installing these suckers. I have been using a old input shaft but the
> bloody things are always going crooked and because they are made of
> brass, bend really easy. I have also soaked them in oil as per the
> prescribed method as they are porous. Same deal. They seem to be a
> little bigger than the actual hole in the crank. I am going to try
> putting one in the freezer for a few days and hopefully that will
> shrink it enough to fit in.
>
> Any ideas/tips greatly appreciated.
> Michael "This is beginning to piss me off" Foreshew
Have you tried putting a bit of grease in the crank to help it slide
in? Also put a bit of a chamfer around the corner going in first.
Did you get the old one out ok?
--
Regards,
Andrew
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.datascribe.com.au/ozdatonline/index.htm
http://www.datascribe.com.au/ozdatonline/listindex.html
---------------------------------------------------------------------
