An L series cam sprocket has 41 teeth so 1 tooth = 8.8 degrees.
terry
Paddy Mcmillan wrote:
> g`day,
> the Z uses the same as the L dont it? 20teeth 180degree so i guess 1 tooth
> is 9degree, correct?
> Paddy
>
> >From: Adam Rowe <[EMAIL PROTECTED]>
> >Reply-To: [EMAIL PROTECTED]
> >To: [EMAIL PROTECTED]
> >Subject: Re: Z18ET cam timing
> >Date: Sat, 13 May 2000 00:58:49 +1000
> >
> >So you are saying that you have advanced the cam by one tooth and that has
> >fixed
> >most of your unhappy performance problems?
> >
> >Peter and Trace wrote:
> >
> > > Hi all,
> > > I just checked and adjusted my tappetts HOT. I noticed also
> >that the
> > > overlap on no.4 was a bit lagging with no. 1 on TDC. I advanced the cam
> > > one tooth (rotated clockwise from the front) and boy did it make a big,
> >and
> > > good difference. Heaps more responsive down low and hence comes on
> >boost
> > > faster. In all that excitement I forgot to listem for the noisy tappet,
> > > the original job!!
> > > How many degrees is one tooth?
> > > Regards,
> > > Pete.
> >
> >--
> >Adam
> >
>
> ________________________________________________________________________
> Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com
>
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.datascribe.com.au/ozdatonline/index.htm
http://www.datascribe.com.au/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
