g`day,
mines got 40 i just counted again to make sure.)
is 9 degree rite tho?? i hope so
ive totally confused myself!!
Paddy
>From: Terry & Heather <[EMAIL PROTECTED]>
>Reply-To: [EMAIL PROTECTED]
>To: [EMAIL PROTECTED]
>Subject: Re: Z18ET cam timing
>Date: Sat, 13 May 2000 20:19:25 +1000
>
>An L series cam sprocket has 41 teeth so 1 tooth = 8.8 degrees.
>
>terry
>
>Paddy Mcmillan wrote:
>
> > g`day,
> > the Z uses the same as the L dont it? 20teeth 180degree so i guess 1
>tooth
> > is 9degree, correct?
> > Paddy
> > >
> > >So you are saying that you have advanced the cam by one tooth and that
>has
> > >fixed
> > >most of your unhappy performance problems?
> > >
> > >Peter and Trace wrote:
> > >
> > > > Hi all,
> > > > I just checked and adjusted my tappetts HOT. I noticed also
> > >that the
> > > > overlap on no.4 was a bit lagging with no. 1 on TDC. I advanced the
>cam
> > > > one tooth (rotated clockwise from the front) and boy did it make a
>big,
> > >and
> > > > good difference. Heaps more responsive down low and hence comes on
> > >boost
> > > > faster. In all that excitement I forgot to listem for the noisy
>tappet,
> > > > the original job!!
> > > > How many degrees is one tooth?
> > > > Regards,
> > > > Pete.
> > >
> > >--
> > >Adam
________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.datascribe.com.au/ozdatonline/index.htm
http://www.datascribe.com.au/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
