Russ,
I can't easily find the factory specs but I recall that the standard spring
rates where around 150# for the front and 600# for the rear which is quite
firm for a factory car in those days. These figures for a typical aftermarket
heavy duty lowered (25-30mm) replacement are ~200# & ~800#.
I missed that you also asked for the rear spring specs
Spring free length = 299 mm or 311 mm
Loaded length = ?
Coil spring diameter = 90 mm
Spring wire diameter = 14.2 mm
>
terry
RUSSCB wrote:
> terry,
>
> Would you have the spring rates for these as well please ?
> Thanks for the information.
>
> Russ
> ----- Original Message -----
> From: "Terry & Heather" <[EMAIL PROTECTED]>
> To: <[EMAIL PROTECTED]>
> Sent: Tuesday, May 30, 2000 11:31 PM
> Subject: Re: Springs
>
> > Russ,
> > The front spring specs you asked for are here:
> >
> > Spring free length = 354.5 mm or 369.5 mm
> > Loaded length = 187 mm or 202 mm
> > Coil spring diameter = 130 mm
> > Spring wire diameter = 12 mm
> >
> > Terry
> >
> > RUSSCB wrote:
> >
> > > Hi List,
> > >
> > > I was wondering if anyone could tell me the free height, wire diameter
> and
> > > inside coil diameter of an original datsun front and rear spring.
> > >
> > > Thanks,
> > > Russ
> > >
> >
> >
> >
> >
>
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.datascribe.com.au/ozdatonline/index.htm
http://www.datascribe.com.au/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
