Zac,
You must go back to stock lash pads with a stock cam. The lash pads from the
mild cam are thicker than stock ones if the cam is a regrind. They gring
material from the base of the cam and you have to use the thicker lash pads
to maintain the stock rocker arm geometry.
Cheers
Feral Errol
mailto:[EMAIL PROTECTED]
http://www.datrats.com.au/
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]]On Behalf Of [EMAIL PROTECTED]
Sent: Thursday, February 22, 2001 12:50 PM
To: [EMAIL PROTECTED]
Subject: Valve/rocker clearance.
List! I swapped my mild cam with a stock C cam yesterday. Today I went to
adjust the valve clearances. I've never done it before and I think I was
doing
it right, but I could not get the rocker to go low enough to create any type
of
gap between the lash pad and cam. Basically I ran out of thread to keep
lowering the rocker.
Are the lash pads from the mild cam too big, ie they need to be swapped for
something smaller?
Cheers!
zac
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
