Errol we ripped them out of an auto 260C
Paid $5 for 8!!!
I'm rather happy :)
zac
----- Original Message -----
From: Errol Smith <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Thursday, February 22, 2001 6:41 PM
Subject: RE: Valve/rocker clearance.
> Zac,
> Rip them out of a L series six cylinder auto (always slower revs used)
from
> a wreckers. They are perfect but will have to have adjustment after 500 -
> 1000 km.
>
> Cheers
> Feral Errol
> mailto:[EMAIL PROTECTED]
> http://www.datrats.com.au/
>
> -----Original Message-----
> From: [EMAIL PROTECTED]
> [mailto:[EMAIL PROTECTED]]On Behalf Of Zac Campbell
> Sent: Thursday, February 22, 2001 5:48 PM
> To: [EMAIL PROTECTED]
> Subject: Re: Valve/rocker clearance.
>
>
> Yeah we kinda figured that out eventually :)
>
> Is it possible to get the lash pads ground down, as a cheaper method of
> getting smaller lash pads? Are second hand lash pads useable?
>
> Cheers!!
> zac
>
> ----- Original Message -----
> From: Errol Smith <[EMAIL PROTECTED]>
> To: <[EMAIL PROTECTED]>
> Sent: Thursday, February 22, 2001 6:03 PM
> Subject: RE: Valve/rocker clearance.
>
>
> > Zac,
> > You must go back to stock lash pads with a stock cam. The lash pads from
> the
> > mild cam are thicker than stock ones if the cam is a regrind. They gring
> > material from the base of the cam and you have to use the thicker lash
> pads
> > to maintain the stock rocker arm geometry.
> > Cheers
> > Feral Errol
> > mailto:[EMAIL PROTECTED]
> > http://www.datrats.com.au/
> >
> > -----Original Message-----
> > From: [EMAIL PROTECTED]
> > [mailto:[EMAIL PROTECTED]]On Behalf Of
> [EMAIL PROTECTED]
> > Sent: Thursday, February 22, 2001 12:50 PM
> > To: [EMAIL PROTECTED]
> > Subject: Valve/rocker clearance.
> >
> >
> > List! I swapped my mild cam with a stock C cam yesterday. Today I went
to
> > adjust the valve clearances. I've never done it before and I think I was
> > doing
> > it right, but I could not get the rocker to go low enough to create any
> type
> > of
> > gap between the lash pad and cam. Basically I ran out of thread to keep
> > lowering the rocker.
> >
> > Are the lash pads from the mild cam too big, ie they need to be swapped
> for
> > something smaller?
> >
> > Cheers!
> > zac
> >
> >
>
>
>
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
