One more step.
The L20 is about 20mm taller in the block than the L16/18. You need to
extend the exhaust pipe up by this amount as the original wont pull up far
enough. You may also find the standard air cleaner hits under the bonnet for
the same reason. A sloppy engine mount on the LHS or a quick cut and reweld
of the LH engine mounting bracket will give enough clearance.
----- Original Message -----
From: "Bruce Ferguson" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Tuesday, 29 May 2001 10:52 AM
Subject: Re: A STUPID QUESTION ABOUT ENGINE SWAP
> Colin,
>
> Yes Daniel is correct, however don't forget to swap
> over the oil pump pickup with the 1600 one as well.
>
> As for the G/Box X/member I would be inclined to get a
> 5 speed and manufacture/purchase/modify a X/Memeber to
> suit. I would prefer to use the existing holes rather
> than drill new ones as the strength is not there
> unless the floor is re-enforced.
>
> Regards
>
> Bruce
>
>
> __________________________________________________
> Do You Yahoo!?
> Yahoo! Auctions - buy the things you want at great prices
> http://auctions.yahoo.com/
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
