Tom when I put the new pipework in the wagon of yours I set it up so that there was
enough room to lift the pipework so that one day I could of put a L20 in It.
But normally no you can't get the pipework to fit.
Iff You can get the pipework to reach the angle of the manifild is on the wrong angla
to bolt up so yes extractors would be the way to go.
Rick White.
--- "Tom Richardson" <[EMAIL PROTECTED]>
> wrote:
>Damien,
>
>Depends I think, the block is only 20mm taller, so it may or may not have
>enough leeway to fit. When I pulled the stock exhaust in my wagon apart
>there was tons of clearance to the firewall to lift the manifold up a bit,
>so it might depend on car to car perhaps?
>
>I have to agree with Justin though, get extractors :)
>
>- Tom
>
>----- Original Message -----
>From: "damien cm" <[EMAIL PROTECTED]>
>To: <[EMAIL PROTECTED]>
>Sent: Tuesday, May 29, 2001 2:17 PM
>Subject: Re: A STUPID QUESTION ABOUT ENGINE SWAP
>
>
>> All,
>>
>> Would'nt you have to change the exhaust manifold cause the block is
>higher??
>>
>> Damien
>>
>> _________________________________________________________________________
>> Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.
_____________________________________________________________
Get Your free Ozdat Email Account
---> http://www.ozdat.com
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
