Yes, I can;
went to picka part, located fresh R31, removed motor and clipped loom and
socket back about 3"
Removed lucas motor from 1600 (used match stick for light :)). Two out of
three bolt holes lined up with new motor,drilled new third bolt hole so all
three bolt holes on R31 matched up. Took actuator arm of Lucas motor and
put on R31 and bolted R31 motor to plenum chamber. Put actuator arm from
datto onto R31.
Wiring....stuffed around and got low speed and return to base sorted; dont
have hight speed sorted yet, no time, working on lowering 1/4 mile :)
If anyone has both high and low speed pls let me know.
cam
----- Original Message -----
From: Terry Rudd <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Thursday, July 19, 2001 11:30 PM
Subject: RE: 1600 Windscreen wipers
> Cam,
>
> Couldn't give us a rough "how you did it" not too much detail just the
basic
> points as this comes up fairly often.
>
> regards,
> Terry
>
> -----Original Message-----
> From: [EMAIL PROTECTED]
> [mailto:[EMAIL PROTECTED]]On Behalf Of Cam
> Sent: Thursday, 19 July 2001 1:21 AM
> To: [EMAIL PROTECTED]
> Subject: Re: 1600 Windscreen wipers
>
>
> I actually fitted an R31 Skyline/Pintara wiper motor. Not to much
stuffing
> around and is nice and speedy!
>
> Cam
>
>
> ----- Original Message -----
> From: Terry Rudd <[EMAIL PROTECTED]>
> To: <[EMAIL PROTECTED]>
> Sent: Tuesday, July 17, 2001 9:13 PM
> Subject: RE: 1600 Windscreen wipers
>
>
> > Simon,
> >
> > 1600 wipers are rated at 32 wpm slow and 48 wpm fast, screen wet and
> engine
> > running.
> >
> > A Jedico wiper motor (horizontal type) is the best one and will do this
> > easily, Lucas if they work at all are good speed, Hitachi (point down at
> 45
> > degrees) are very slow in comparison. You may be able to improve your
> wiper
> > performance by greasing all of the rods etc as resistance will hurt your
> > motor a lot.
> >
> > regards
> > Terry
> >
> > -----Original Message-----
> > From: [EMAIL PROTECTED]
> > [mailto:[EMAIL PROTECTED]]On Behalf Of Simon Brown
> > Sent: Tuesday, 17 July 2001 8:27 PM
> > To: [EMAIL PROTECTED]
> > Subject: 1600 Windscreen wipers
> >
> >
> > I would like to increase the speed of my 1600's windscreen wipers.
> >
> > The RTA NSW regs' state that "Two speed windscreen wipers with a fast
> speed
> > of at least 45 cycles per minute and a slow speed of at least 20 cycles
> per
> > minute" are required.
> >
> > I haven't timed mine to see if they meet this spec' but they are pretty
> > dismal
> > compared to a late model car. No use having all this new found
performance
> > if
> > you can't see where you're going.....
> >
> > Any info on this subject would be greatly appreciated.
> >
> > Thanks
> > Simon Brown
> >
> >
>
>
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
