trev thats correct use the R31 disc Dennis cope is running those on his car and i'm the same only R31 calipers
Peter ----- Original Message ----- From: "Pooley, Trevor" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Tuesday, December 11, 2001 1:45 PM Subject: Vented disks under 13 inch wheels > List, > > Following on from a thread a few weeks back. I am looking into a conversion > for running vented disks under 13 x 7 wheels (hotwires for example). Plan > was to use the Sumitomo twin opposed piston calliper on a 240K strut (253mm > diameter disk, 48mm hub and 12.7mm thick). I would need to use a spacer in > the centre of the calliper to accommodate a vented disk. Question is which > disk to use. The R31 hub type vented disk has about the right specs ie 250mm > diameter, 48mm hub and 22mm vented, But being hub type is probably a > different disk offset. The 240K disk has the hub bolted to it. > > Ideally a disk with the same offset to the calliper bracket would be the > easiest to fit as there would be no change to the calliper bracket. Anything > more than a 22mm vent would probably cause the spaced out part of the > calliper to fowl on the wheel. In the DBA cataloge the S12 gazzelle look > like a good canidate and it might be possible to take the hub to if the > height is correct. Does anyne know? The s13 sivia looks like a good match > also. The 280zx could work depending if the hub will fit the 240K strut and > provide the right offset. > > Anyone know what would work the best? > Thanks > Trev > > > --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/[email protected]/ ---------------------------------------------------------------------
