Hi Trev sorry mate I've got a bit of bad news. The car is not blue anymore.
----- Original Message ----- From: "Pooley, Trevor" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Wednesday, December 12, 2001 5:16 PM Subject: RE: Vented disks under 13 inch wheels > Peter, > > Looks like I will have to check it out at the wreckers along with the 280zx > disks. When I read Hub Type on the DBA catalog I think about Bluebird disk > which has a much different offset. > > I've been meaning to catch up. Next time your racing locally give me a yell > I want to check out the new Blue SR powered car. > > Cheers > Trev > > -----Original Message----- > From: Mr-Freeze [mailto:[EMAIL PROTECTED]] > Sent: Tuesday, 11 December 2001 16:05 > To: [EMAIL PROTECTED] > Subject: Re: Vented disks under 13 inch wheels > > > trev > thats correct use the R31 disc > Dennis cope is running those on his car and i'm the same only R31 calipers > > Peter > ----- Original Message ----- > From: "Pooley, Trevor" <[EMAIL PROTECTED]> > To: <[EMAIL PROTECTED]> > Sent: Tuesday, December 11, 2001 1:45 PM > Subject: Vented disks under 13 inch wheels > > > > List, > > > > Following on from a thread a few weeks back. I am looking into a > conversion > > for running vented disks under 13 x 7 wheels (hotwires for example). Plan > > was to use the Sumitomo twin opposed piston calliper on a 240K strut > (253mm > > diameter disk, 48mm hub and 12.7mm thick). I would need to use a spacer in > > the centre of the calliper to accommodate a vented disk. Question is which > > disk to use. The R31 hub type vented disk has about the right specs ie > 250mm > > diameter, 48mm hub and 22mm vented, But being hub type is probably a > > different disk offset. The 240K disk has the hub bolted to it. > > > > Ideally a disk with the same offset to the calliper bracket would be the > > easiest to fit as there would be no change to the calliper bracket. > Anything > > more than a 22mm vent would probably cause the spaced out part of the > > calliper to fowl on the wheel. In the DBA cataloge the S12 gazzelle look > > like a good canidate and it might be possible to take the hub to if the > > height is correct. Does anyne know? The s13 sivia looks like a good match > > also. The 280zx could work depending if the hub will fit the 240K strut > and > > provide the right offset. > > > > Anyone know what would work the best? > > Thanks > > Trev > > > > > > > > --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/[email protected]/ ---------------------------------------------------------------------
