Mark, I just had a look at the DBA online catalog. A lot of those Audi disk are a good match.
240K is 253mm diameter 48mm hat height and 12.7mm thick. DBA catalog number 241 is 256mm diameter 47mm hat height and 22mm thick. Mark, what caliper are you running? Sumitomo twin pot? Regards Trev -----Original Message----- From: Mark Alford [mailto:[EMAIL PROTECTED]] Sent: Tuesday, 11 December 2001 16:05 To: [EMAIL PROTECTED] Subject: Re: Vented disks under 13 inch wheels Trevor, I have a 260mm vented disk but it was on the car when I got it. Errol was telling me about an Audi disk from DBA that will fit but requires spacing of the caliper as you stated, I can't remember though which Audi it was from, maybe Errol can help out on this one, as I am thinking of updating my rotors also. Mark. P.S. the shocks were supposed to be ready last Friday, but I have been too busy to get up there. I will try to get them this week. ----- Original Message ----- From: "Pooley, Trevor" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Tuesday, December 11, 2001 1:45 PM Subject: Vented disks under 13 inch wheels > List, > > Following on from a thread a few weeks back. I am looking into a conversion > for running vented disks under 13 x 7 wheels (hotwires for example). Plan > was to use the Sumitomo twin opposed piston calliper on a 240K strut (253mm > diameter disk, 48mm hub and 12.7mm thick). I would need to use a spacer in > the centre of the calliper to accommodate a vented disk. Question is which > disk to use. The R31 hub type vented disk has about the right specs ie 250mm > diameter, 48mm hub and 22mm vented, But being hub type is probably a > different disk offset. The 240K disk has the hub bolted to it. > > Ideally a disk with the same offset to the calliper bracket would be the > easiest to fit as there would be no change to the calliper bracket. Anything > more than a 22mm vent would probably cause the spaced out part of the > calliper to fowl on the wheel. In the DBA cataloge the S12 gazzelle look > like a good canidate and it might be possible to take the hub to if the > height is correct. Does anyne know? The s13 sivia looks like a good match > also. The 280zx could work depending if the hub will fit the 240K strut and > provide the right offset. > > Anyone know what would work the best? > Thanks > Trev > > > > _____________________________________________________________________ This message has been checked for all known viruses by the MessageLabs Virus Scanning Service. For further information visit http://www.messagelabs.com/stats.asp --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/[email protected]/ ---------------------------------------------------------------------
