Ottens, try Rotary Automotive at therbarton, they sell 13b turbos and intercoolers quite cheap (last I was told).
When I upgrade my turbs I will be keeping the 12a exhaust housing and the rest of the series 5 gear on the front. that way it shouldn't spool any later and I will have a nice fat compressor side too :) just without the carbon seal, cos I don't need it :) zac ----- Original Message ----- From: "andrew smith" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Wednesday, May 29, 2002 4:10 PM Subject: Re: suck thru turbo setup...... > Ryan, > It probably wouldnt see fullboost under 4k.There usually pretty cheap $150-$350. > > Ryan Ottens wrote: > > > andrew, > > i might give AFR (adelaide fours and rotaries) which now just deal with > > rotories i hear. see what turbos they got. so a S4 turbo should do the job? > > a bit of lag up to 3-3.5k wont really bother me too much. > > what sort of price would i be looking at?? > > > > cheers, > > ryan > > > > >From: andrew smith <[EMAIL PROTECTED]> > > >Reply-To: [EMAIL PROTECTED] > > >To: [EMAIL PROTECTED] > > >Subject: Re: suck thru turbo setup...... > > >Date: Wed, 29 May 2002 06:18:09 +0800 > > > > > >Ryan, > > >Any of the TO3's and TO4's can be converted to carbon seal but its not > > >cheap > > >new.Best off finding a second hand one thats already been done. The 13b > > >rota > > >turbos use a carbon seal standard but are pretty laggy due to there large > > >turbine A/R's (S4 is .88,S5 is 1.0).There is a guy on the sr list that uses > > >one and gets 230rwhp at 20psi.Some turbo place will fit these turbos onto a > > >smaller t3 turbine housing to get less lag.Forget the idea of sucking thru > > >a > > >B/B turbo. > > > > > >Ryan Ottens wrote: > > > > > > > hey list, > > > > i want to go suck thru turbo on my L20b. > > > > now as the petrol/air mix will be going thru the turbo it has to be > > >carbon > > > > sealed? > > > > > > > > is this an expensive jobt o get it sealed? any ideas of what sort of > > >turbo > > > > would be good to use on L20b for about 13-16psi? > > > > T28 roller bearing? > > > > > > > > any ideas and prices would be great. > > > > thanks, > > > > ryan > > > > > > > > _________________________________________________________________ > > > > Send and receive Hotmail on your mobile device: http://mobile.msn.com > > > > > > > > > > > _________________________________________________________________ > > Send and receive Hotmail on your mobile device: http://mobile.msn.com > > > > --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/[email protected]/ ---------------------------------------------------------------------
