|
im gunan be putting c210 IRS in the bluey later
on.....how difficult would it be fitting a s13/r32/33 R200 into the
setup???
----- Original Message -----
Sent: Thursday, September 05, 2002 7:01
AM
Subject: RE: S13 Lsds
The
later S13 style viscous LSD uses a left side axle with 2 sets of slpines on
it. One spline connect to the side gear and the second set of splines to the
viscous clutch pack. The Viscous clutch pack is only approximately 12 mm thick
and wea out very quickly with any decent torque put through them. Also the
make them work you must use the axles that came with the centre. Also there
are two spline distances on the left axle depending on model. All to much
trouble.
I
also looked at changing the later viscous diffs to early clutch pack, but this
is also a pain due to crown wheel offset distances being
different.
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to
[EMAIL PROTECTED]
Send submissions to
[EMAIL PROTECTED]
No unauthorised redistribution of this
email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
--------------------------------------------------------------------- |
