I keep blowing head gaskets due to the fact that the o-rings in the blcok are sqeezing the metal rings on the Z18/Z20 gaskets into the cylinder just enough for the piston to hit it and cause water leaking into the chamber.
Seeing as the Z22 is only 1mm larger in diametre than the Z20 gasket, I was thinking using a Z22 gasket and this just might be enough so it wont blow?
I dont really want to have to rip the whole block out and get the o-rings taken out :/
_________________________________________________________________
Hot chart ringtones and polyphonics. Go to http://ninemsn.com.au/mobilemania/default.asp
--membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/[EMAIL PROTECTED]/ ---------------------------------------------------------------------
