check the ignition switch sometimes we hapen to ignore things and these are the very
small stuff which gives problems.
-----Original Message-----
From: Andrew Smith [mailto:[EMAIL PROTECTED]
Sent: Sunday, May 16, 2004 11:29 PM
To: [EMAIL PROTECTED]
Subject: Re: CA18DET won't start... again
I would double check that you have 12 volts in both the run and cranking
positions and any where in between.Some ecu's are sensative to any voltage
drops between the run and cranking positions and will reset.
----- Original Message -----
From: "Mark Firman" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Sunday, May 16, 2004 6:34 PM
Subject: Re: CA18DET won't start... again
> I pulled the crank angle sensor off and span it with the ignition on and i
> could hear injectors ticking away but there was definantly no spark :(
It's
> got me a bit stumped! Anyone got any ideas??
> Thanks,
> Mark Firman
>
> ----- Original Message -----
> From: "Cameron Stean" <[EMAIL PROTECTED]>
> To: <[EMAIL PROTECTED]>
> Sent: Sunday, May 16, 2004 1:02 PM
> Subject: RE: CA18DET won't start... again
>
>
> > check to see if the crank angle sensor is sending signals to the ecu.
> >
> >
> > >From: "Mark Firman" <[EMAIL PROTECTED]>
> > >Reply-To: [EMAIL PROTECTED]
> > >To: "OZDAT" <[EMAIL PROTECTED]>
> > >Subject: CA18DET won't start... again
> > >Date: Sun, 16 May 2004 10:49:27 +1000
> > >
> > >Hi,
> > >It's just problem after problem with my car! I hooked up my surge tank
> and
> > >pump and got my fuel system all finished and looking good - but now the
> > >thing won't spark!
> > >It turns over and has fuel pumping in, but it won't spark until you let
> the
> > >key back off the cranking position......
> > >We checked the power at all the relays in case the 1600 barrel wasn't
> > >letting 12v through when in the start position but that wasn't it,
power
> is
> > >there but it just isn't sparking..
> > >It has done this before a few months ago when i was trying to get it
> > >started, and from memory all i did was take the plugs out and clean
them
> up
> > >and then noticed that they sparked when i turned it over, so i put them
> > >back in and off she went. I've tried that this time but it was no
help...
> > >it seems like it could be one of those annoying intermittant problems
:(
> > >If anyone has any ideas or suggestions of what i should try to get it
> going
> > >again that would be really appreciated. I am close to getting the thing
> on
> > >the road now, only not if it wont start!!
> > >Thanks,
> > >Mark Firman
> > >
> >
> > _________________________________________________________________
> > SEEK: Now with over 50,000 dream jobs! Click here:
> > http://ninemsn.seek.com.au?hotmail
> >
> >
> >
>
>
>
>
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[EMAIL PROTECTED]/
---------------------------------------------------------------------
This email and any files transmitted with it are confidential and intended solely for
the use of the individual or entity to whom they are addressed. If you have received
this mail in error, please notify the System Administrator. Please note that any views
or opinions presented in this mail are solely those of the author and do not
necessarily
represent those of the Institute. Finally the recipient should check this mail and any
attachment for the presence of viruses. FIT has a virus detection in place and makes
every reasonable effort to ensure that this message is free from viruses. FIT accepts
no liability for any damage caused by any virus transmitted by this mail
