Since that SS pipe is fairly short the WI nozzle would only be 1-2 inches pre- AIT sensor - is that too close? Is there any downside to relocating the AIT sensor to the intake manifold? Heat soak?
Alternatively, is there a reason not to place the WI nozzle near the IC outlet? Thanks, Mike -------------- Original message ---------------------- From: "Bill Cardell" <[EMAIL PROTECTED]> > I would go before the intake sensor in the ss tube. FWIW, I saw a peak > IAT of 32C at Thunderhill at 16.5psi on the Westie with WI. A couple > weeks earlier with no ic and iat before the water nozzle I was seeing > 160C! With no knock... > > > Bill Cardell > TurboDog's Dad > www.flyinmiata.com > 1-800-FLY-MX5S (sales) > 970-464-5600 (tech) > 2008 FM Open House: August 14-17 > > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of > [EMAIL PROTECTED] > Sent: Monday, April 28, 2008 12:20 PM > To: MiataPower > Subject: Question regarding installation of Water Injection kit > > Where is a good place to install the WI nozzles? Should I weld on some > bungs to the top of the IC? Since I have silicone intake hoses the only > other option is to tap the stainless steel tube where the AIT is located > or weld in some bungs into the intake manifold, but that is AFTER the > intake temps are read. > > > Thanks, > Mike > _______________________________________________ > Miatapower mailing list > [email protected] > http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower _______________________________________________ Miatapower mailing list [email protected] http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower
