He did say he eliminated the AC belt by running the car without it or I would have suggested making sure the AC unit wasn't loose on the engine. I went nuts on my 91 for months working on a belt that kept loosening up until I found the mounting bracket was loose on the engine and the AC unit was fine on the mounting bracket. I finally figured it out when I removed the belt and could wiggle the AC compressor but didn't see the compressor moving in relation to the bracket.
Larry White Knight 1991 Crystal White #99 CSP Silver Bullet 1992 Silverstone #17 SM2 FM I+ Turbo Honey B 1992 Sunburst Yellow #99 SM2L JR Supercharger Whooosh 2004 Titanium Mazdaspeed MX-5 LowCountry Miata http://www.lowcountrymiataclub.net Masters Miata RAGS 074 -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Bill Cardell Sent: Friday, August 08, 2008 7:07 PM To: [EMAIL PROTECTED]; [email protected] Subject: RE: belt squeal & alternator voltage I'm with Larry about glazed belt, but double check that the a/c compressor isn't always running. Also, have you talked to Jeremy about the alt control? Besides the PWM map, you also have PID parameters to play with. Bill Cardell TurboDog's Dad www.flyinmiata.com www.fmwestfield.com Sales 1-800-359-6957 Tech 970-464-5600 Before you call, check out http://www.flyinmiata.com/FAQ/ Come to our Open House! August 14-17 -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Ian McCloghrie Sent: Friday, August 08, 2008 3:58 PM To: [email protected] Subject: belt squeal & alternator voltage I've been trying to fix belt squeal at startup on my Miata for a while, without much luck. Originally, it only happened at startup when the engine was cold. Gradually, it started happening more often, and lasting longer (first 5-10 seconds). I replaced the belts (it's the water pump/alternator belt doing it, because it did it with the PS belt off, and not with the water pump belt off). That made it go away for a couple weeks, but then it started coming back. I've checked the tension, and it appears to be fine. It's getting worse to the point where now it'll squeal at low RPM when pulling away from a stop sign as well, even when things are warmed up. Any thoughts? Is it possible that it's resulting from excessive load from the alterator and/or water pump? I'm a little suspicious of the alternator, because the voltage sags substantially with lots of electrical load. Idle voltages can be as high as 14.5 with no electrical loads, or as low as 11.5 if I've got everything on (blower, head/brake lights, defroster, etc). Also, voltage droops into the 11-12 range at high RPM (say 6K) at full boost. On an open freeway onramp at night, the headlights dim noticably as the RPM rises. Did an alternator test with Autozone's machine, they said it was fine. Of course, they did it at 2000 RPM, not at idle. The car is a 99, 80K miles, FM2 for 50K of those, currently using a Hydra. The Hydra says it's driving the alternator as hard as it'll go, although I haven't actually checked the voltage on the control wire to see if it's telling the truth. The alternator is original, the water pump has approx 20K miles on it. --Ian _______________________________________________ Miatapower mailing list [email protected] http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower _______________________________________________ Miatapower mailing list [email protected] http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower _______________________________________________ Miatapower mailing list [email protected] http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower
