Might want to consider a spritz of water instead of brake fluid.  It does 
about the same thing and does not fling off to bubble the paint.


----- Original Message ----- 
From: "Larry Alster" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>; "'Bill Cardell'" <[EMAIL PROTECTED]>
Cc: <[email protected]>
Sent: Friday, August 08, 2008 7:56 PM
Subject: RE: belt squeal & alternator voltage


Slipping glazes the belt.  Just a few minutes of running a belt slipping
could glaze it. That's why I suggested trying a little brake fluid on it to
see if it changes the noise.  It adds some grip.  Silly questions, your
alternator and water pump pulleys turn freely and easily without the belt
on?  Also your crank pulley isn't wobbling??



Larry

White Knight 1991 Crystal White #99 CSP
Silver Bullet 1992 Silverstone #17 SM2 FM I+ Turbo
Honey B 1992 Sunburst Yellow #99 SM2L JR Supercharger
Whooosh 2004 Titanium Mazdaspeed MX-5

LowCountry Miata http://www.lowcountrymiataclub.net
Masters Miata
RAGS 074

-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On Behalf Of Ian McCloghrie
Sent: Friday, August 08, 2008 7:49 PM
To: Bill Cardell
Cc: [email protected]
Subject: Re: belt squeal & alternator voltage

On Aug 8, 2008 "Bill Cardell" wrote:
> I'm with Larry about glazed belt, but double check that the a/c
> compressor isn't always running. Also, have you talked to Jeremy about
> the alt control? Besides the PWM map, you also have PID parameters to
> play with.

It's definitely not the AC compressor running all the time (verified
by running w/o AC belt, also the effect on the idle when the
compressor kicks in is not subtle).

I replaced the belt once -- that fixed it for a week or two.  What
glazes belts?  Is it possible to glaze one that quickly?

I've talked to Jeremy about the alternator control a couple of times,
although I haven't played with the PID settings.  Do they happen
"before" or "after" the PWM map?  That is, does it the PID circuit
pick where on the map to use, or does it take the output of the map
and then use PID to try to make the alternator match up to it?

--Ian
_______________________________________________
Miatapower mailing list
[email protected]
http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower

_______________________________________________
Miatapower mailing list
[email protected]
http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower 

_______________________________________________
Miatapower mailing list
[email protected]
http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower

Reply via email to