After much calling, screwing around and very little progress (Griffin was the best fit, but $$$ comes into play I think.. thanks Bill for that lead tho) I realized that is going to be the cheapest/fastest bet. It's water, a little 45/45 corner isn't that big of an issue plus I can get very tight to the end tank this way. Plus straight pipe is $1.25 a foot vs. $24+ a corner plus time plus whatever.
Thanks!
Wallyman
Ashraf Farrag
<[email protected]
rg> To
[email protected]
02/23/2009 01:53 PM cc
[email protected]
Subject
Please respond to Re: Where to buy Aluminum
[email protected] radiator components? NMC
g
[email protected] wrote:
> Need to have my RX7 radiator modified, it's all alum. and I need the
> lower hose connection changed from a straight to a tight 90 with a
> pipe going up the side to another 90 at the top.
Straight piece of pipe, cut at 45 degrees, weld the two angled parts
together. Use bead-form to put bead on end and weld to radiator. Built
two custom radiators myself in the home shop this way. Cut-n-weld
mandrel bent aluminum pipe for the not-so-tight space stuff.
--Ashraf
<<inline: graycol.gif>>
<<inline: pic01908.gif>>
<<inline: ecblank.gif>>
_______________________________________________ Miatapower mailing list [email protected] http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower
