Sorry,i dont think getif supports snmpv2. However in most cases you should be getting a snmp response from the device(such as the device info) using getif irrespective of the snmp version the device uses(apart from snmpv3). However as steve pointed it out, it might be that the devices supports only snmpv2 which is rarely the case. So i think it might be a config issue on your device rather than the problem with MRTG or getif.
Best regards Venkat --- On Wed, 8/26/09, Nicolás Quesada <[email protected]> wrote: From: Nicolás Quesada <[email protected]> Subject: Re: [mrtg] riverstone To: "Steve Shipway" <[email protected]> Cc: "[email protected]" <[email protected]> Date: Wednesday, August 26, 2009, 3:52 AM thanks a lot. so clear. i'll follow these steps. only one more question: can i change the SNMP version value in GETIF? i cannot find where thanks a lot! On 8/26/09, Steve Shipway <[email protected]> wrote: > It looks to me very much that you have either (1) the wrong SNMP community, > or, more likely, (2) the device ACLs are not set as you think they are. > > Since even getif and snmpwalk don't work, its not a MRTG or cfgmaker issue. > > Since someone else is doing this successfully, the device clearly supports > SNMP. > > Check the following - > 1. The device has SNMP enabled, but maybe it only have SNMPv2 enabled? Try > doing a walk with SNMPv2c rather than SNMPv1 > 2. Check the ACLs - maybe that community is only enabled for certain IP > addresses? > 3. Find the person who has working SNMP - get them to take a look at your > config :). Ask them which SNMP version they are using, who set up the > router, etc. > 4. Possibly there is a firewall between you and this router that is blocking > SNMP? > > Steve > > _______________________________________________ mrtg mailing list [email protected] https://lists.oetiker.ch/cgi-bin/listinfo/mrtg
_______________________________________________ mrtg mailing list [email protected] https://lists.oetiker.ch/cgi-bin/listinfo/mrtg
