thanks a lot. so clear. i'll follow these steps. only one more question: can i change the SNMP version value in GETIF? i cannot find where
thanks a lot! On 8/26/09, Steve Shipway <[email protected]> wrote: > It looks to me very much that you have either (1) the wrong SNMP community, > or, more likely, (2) the device ACLs are not set as you think they are. > > Since even getif and snmpwalk don't work, its not a MRTG or cfgmaker issue. > > Since someone else is doing this successfully, the device clearly supports > SNMP. > > Check the following - > 1. The device has SNMP enabled, but maybe it only have SNMPv2 enabled? Try > doing a walk with SNMPv2c rather than SNMPv1 > 2. Check the ACLs - maybe that community is only enabled for certain IP > addresses? > 3. Find the person who has working SNMP - get them to take a look at your > config :). Ask them which SNMP version they are using, who set up the > router, etc. > 4. Possibly there is a firewall between you and this router that is blocking > SNMP? > > Steve > > _______________________________________________ mrtg mailing list [email protected] https://lists.oetiker.ch/cgi-bin/listinfo/mrtg
