Do you happen to have a 74L02? Try slewing the FF clock signal its pin 3, 47pf to ground.
Finally, bypass U17 completely (bend out its pin 4, jumper 3-4 on the back of the board, disconnect R34. John From: [email protected] [mailto:[email protected]] On Behalf Of Thomas Owen Sent: Monday, June 9, 2014 12:28 PM To: [email protected] Subject: [N8VEM-S100:4082] Re: CF IDE card checkout and final assembly problem UPDATE: As mentioned, I set up a delay by using the 2 unused gates on the 74LS02 to delay the clock signal to the flip flop. Drive selection now works perfectly. I will see if I can get a screen shot from the analyzer showing the relationship of DO0 to the clock, but for now, here is what I did: U15 pin 1 -> U15 pin 5/6 | U15 pin 4 -> U15 pin 8/9 | U15 pin 10 -> U16 pin 3 Thomas On Sunday, June 8, 2014 7:58:45 PM UTC-4, Thomas Owen wrote: All, I had posted this to the thread dealing with ordering this card, but decided to post a new topic dealing with the problem I have had with final checkout of the board. During assembly the board passed all the 'in progress' checks. The final steps were to output to different ports: I have output the following and everything passes: QO33,80 ; Configures ports A, B and C as output ports QO32,2B ; Selects right hand pair of digits QO30,01; display 01on right digit pair and work through each bit - all ok QO32,2c; Selects middle pair of digits QO30,01; Should display 01 on middle digit pair, work through each bit - all ok QO32,2d; Selects left hand pair of digits QO31,01; Should display 01 on left digit pair, work through each bit - all ok All displays are correct. Now the final step is the Drive Select and that is where I am having trouble: Board always comes up with 'Drive A' selected Now, QO34,0; no change Reset, start again: QO34,1; no change I can never select drive B. Several generous members (thank you David Fry) have made suggestions, and here is where I now stand: My preliminary check this afternoon shows me that there is a timing issue at U15, the 74ls02. Using my logic analyzer and monitoring the inputs and the output (which clocks the drive select flip flop) I see a big timing difference between SEL_SECOND and WR. What this means is that the output of the gate never goes high allowing the bit change to effect drive change/selection. I am going to get some screen shots from the analyzer tomorrow, and if anyone has any suggestions I would greatly appreciate it. Thanks, Thomas -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
