Hi Brian,
Is this on a per channel basis, or right across the board? If it is
individual channels, it is probably a bad solder joint on the pan pot.
This is really common on the Elite and may also happen on the Elan.
best,
Ike
Brian Simmons wrote:
I bought a Neotek Elan II about 3 years ago and have run into a problem with my Aux A/B section. When I pan
the individual channel Aux A/B to the right I get a full sinal out of "B" but if I pan to the left
, I get a very low level signal that sounds a bit distorted out of "A". When I solo the master send
for "A" its the same low level distorted signal.
I have very little experience in electronics so any help would be greatly
appreciated.
thanks
-Brian
------
You can unsubscribe at anytime by sending an email to mailto:[email protected] with
"unsubscribe neotek" in the message body. If you have any difficulties, or
questions --please send an email to [email protected].
The Neotek list is lovingly hosted by Catapult Web Development. Remember that
any message or reply sent to the list will be automatically forwarded to all
subscribers.
Vive Le Neotek !
Thanks.
--
Ike Zimbel
Zimbel Audio Productions Ltd.
Toronto
416-720-0887
"Studio House Calls" - Repairs and upgrades to analog audio equipment including:
Amek, Allen & Heath, Neve, Neotek, MCI, Soundcraft and more.
------
You can unsubscribe at anytime by sending an email to mailto:[email protected] with
"unsubscribe neotek" in the message body. If you have any difficulties, or
questions --please send an email to [email protected].
The Neotek list is lovingly hosted by Catapult Web Development. Remember that
any message or reply sent to the list will be automatically forwarded to all
subscribers.
Vive Le Neotek !
Thanks.
