Ok , thanks Greg I appreciate all you guys help , hopefully it will be something simple as im not very savy with electical stuff
-Brian --- On Tue, 1/6/09, Ike Zimbel <[email protected]> wrote: > From: Ike Zimbel <[email protected]> > Subject: Re: NEOTEK: problem with my Neotek Elan II > To: [email protected] > Date: Tuesday, January 6, 2009, 3:34 PM > Both good points, too! > iz > > Greg Norman wrote: > > Check that the crimping on the connection to the Aux A > bus buffer amp is good. Make sure that nothing is shorting > the Aux A output as well (disconnect, or dead patch any > normaled connections). > > Greg Norman > > Electrical Audio Recording > > 773.539.2555 > > www.electrical.com > > > > > > > > On Jan 6, 2009, at 2:21 PM, Brian Simmons wrote: > > > >> Hi ! > >> Thanks alot for your quick reply ! > >> > >> It seems to be the same for all the channels. > >> > >> -Brian > >> > >> > >> --- On Tue, 1/6/09, Ike Zimbel > <[email protected] > <mailto:[email protected]>> wrote: > >> > >>> From: Ike Zimbel <[email protected] > <mailto:[email protected]>> > >>> Subject: Re: NEOTEK: problem with my Neotek > Elan II > >>> To: [email protected] > <mailto:[email protected]> > >>> Date: Tuesday, January 6, 2009, 2:33 PM > >>> Hi Brian, > >>> Is this on a per channel basis, or right > across the > >>> board? If it is individual channels, it is > probably a bad solder joint on > >>> the pan pot. This is really common on the > Elite and may also happen on > >>> the Elan. > >>> best, > >>> Ike > >>> > >>> Brian Simmons wrote: > >>>> I bought a Neotek Elan II about 3 years > ago and have > >>> run into a problem with my Aux A/B section. > When I pan the > >>> individual channel Aux A/B to the right I get > a full sinal > >>> out of "B" but if I pan to the left > , I get a very > >>> low level signal that sounds a bit distorted > out of > >>> "A". When I solo the master send for > "A" > >>> its the same low level distorted signal. > >>>> I have very little experience in > electronics so any > >>> help would be greatly appreciated. > >>>> > >>>> thanks > >>>> -Brian > >>>> > >>>> > >>>> > >>>> > >>>> > >>>> > >>>> ------ > >>>> > >>>> You can unsubscribe at anytime by sending > an email to > >>> mailto:[email protected] with > "unsubscribe > >>> neotek" in the message body. If you have > any > >>> difficulties, or questions --please send an > email to > >>> [email protected] > <mailto:[email protected]>. > >>>> > >>>> The Neotek list is lovingly hosted by > Catapult Web > >>> Development. Remember that any message or > reply sent to the > >>> list will be automatically forwarded to all > subscribers. > >>>> Vive Le Neotek ! > >>>> > >>>> Thanks. > >>>> > >>>> > >>> > >>> -- Ike Zimbel > >>> Zimbel Audio Productions Ltd. > >>> Toronto > >>> 416-720-0887 > >>> "Studio House Calls" - Repairs and > upgrades to > >>> analog audio equipment including: Amek, Allen > & Heath, > >>> Neve, Neotek, MCI, Soundcraft and more. > >>> > >>> > >>> ------ > >>> > >>> You can unsubscribe at anytime by sending an > email to > >>> mailto:[email protected] with > "unsubscribe > >>> neotek" in the message body. If you have > any > >>> difficulties, or questions --please send an > email to > >>> [email protected] > <mailto:[email protected]>. > >>> > >>> The Neotek list is lovingly hosted by > Catapult Web > >>> Development. Remember that any message or > reply sent to the > >>> list will be automatically forwarded to all > subscribers. > >>> Vive Le Neotek ! > >>> > >>> Thanks. > >> > >> > >> > >> ------ > >> > >> You can unsubscribe at anytime by sending an email > to mailto:[email protected] with "unsubscribe > neotek" in the message body. If you have any > difficulties, or questions --please send an email to > [email protected] <mailto:[email protected]>. > >> > >> The Neotek list is lovingly hosted by Catapult > Web Development. Remember that any message or reply sent to > the list will be automatically forwarded to all subscribers. > >> Vive Le Neotek ! > >> > >> Thanks. > > > > -- Ike Zimbel > Zimbel Audio Productions Ltd. > Toronto > 416-720-0887 > "Studio House Calls" - Repairs and upgrades to > analog audio equipment including: Amek, Allen & Heath, > Neve, Neotek, MCI, Soundcraft and more. > > > ------ > > You can unsubscribe at anytime by sending an email to > mailto:[email protected] with "unsubscribe > neotek" in the message body. If you have any > difficulties, or questions --please send an email to > [email protected]. > > The Neotek list is lovingly hosted by Catapult Web > Development. Remember that any message or reply sent to the > list will be automatically forwarded to all subscribers. > Vive Le Neotek ! > > Thanks. ------ You can unsubscribe at anytime by sending an email to mailto:[email protected] with "unsubscribe neotek" in the message body. If you have any difficulties, or questions --please send an email to [email protected]. The Neotek list is lovingly hosted by Catapult Web Development. Remember that any message or reply sent to the list will be automatically forwarded to all subscribers. Vive Le Neotek ! Thanks.
