Both good points, too!
iz
Greg Norman wrote:
Check that the crimping on the connection to the Aux A bus buffer amp
is good. Make sure that nothing is shorting the Aux A output as well
(disconnect, or dead patch any normaled connections).
Greg Norman
Electrical Audio Recording
773.539.2555
www.electrical.com
On Jan 6, 2009, at 2:21 PM, Brian Simmons wrote:
Hi !
Thanks alot for your quick reply !
It seems to be the same for all the channels.
-Brian
--- On Tue, 1/6/09, Ike Zimbel <[email protected]
<mailto:[email protected]>> wrote:
From: Ike Zimbel <[email protected]
<mailto:[email protected]>>
Subject: Re: NEOTEK: problem with my Neotek Elan II
To: [email protected] <mailto:[email protected]>
Date: Tuesday, January 6, 2009, 2:33 PM
Hi Brian,
Is this on a per channel basis, or right across the
board? If it is
individual channels, it is probably a bad solder joint on
the pan pot.
This is really common on the Elite and may also happen on
the Elan.
best,
Ike
Brian Simmons wrote:
I bought a Neotek Elan II about 3 years ago and have
run into a problem with my Aux A/B section. When I pan the
individual channel Aux A/B to the right I get a full sinal
out of "B" but if I pan to the left , I get a very
low level signal that sounds a bit distorted out of
"A". When I solo the master send for "A"
its the same low level distorted signal.
I have very little experience in electronics so any
help would be greatly appreciated.
thanks
-Brian
------
You can unsubscribe at anytime by sending an email to
mailto:[email protected] with "unsubscribe
neotek" in the message body. If you have any
difficulties, or questions --please send an email to
[email protected] <mailto:[email protected]>.
The Neotek list is lovingly hosted by Catapult Web
Development. Remember that any message or reply sent to the
list will be automatically forwarded to all subscribers.
Vive Le Neotek !
Thanks.
--
Ike Zimbel
Zimbel Audio Productions Ltd.
Toronto
416-720-0887
"Studio House Calls" - Repairs and upgrades to
analog audio equipment including: Amek, Allen & Heath,
Neve, Neotek, MCI, Soundcraft and more.
------
You can unsubscribe at anytime by sending an email to
mailto:[email protected] with "unsubscribe
neotek" in the message body. If you have any
difficulties, or questions --please send an email to
[email protected] <mailto:[email protected]>.
The Neotek list is lovingly hosted by Catapult Web
Development. Remember that any message or reply sent to the
list will be automatically forwarded to all subscribers.
Vive Le Neotek !
Thanks.
------
You can unsubscribe at anytime by sending an email to
mailto:[email protected] with "unsubscribe neotek" in the
message body. If you have any difficulties, or questions --please
send an email to [email protected] <mailto:[email protected]>.
The Neotek list is lovingly hosted by Catapult Web Development.
Remember that any message or reply sent to the list will be
automatically forwarded to all subscribers.
Vive Le Neotek !
Thanks.
--
Ike Zimbel
Zimbel Audio Productions Ltd.
Toronto
416-720-0887
"Studio House Calls" - Repairs and upgrades to analog audio equipment including:
Amek, Allen & Heath, Neve, Neotek, MCI, Soundcraft and more.
------
You can unsubscribe at anytime by sending an email to mailto:[email protected] with
"unsubscribe neotek" in the message body. If you have any difficulties, or
questions --please send an email to [email protected].
The Neotek list is lovingly hosted by Catapult Web Development. Remember that
any message or reply sent to the list will be automatically forwarded to all
subscribers.
Vive Le Neotek !
Thanks.
