Hi I have an 83 Nighthawk and I am having a problem getting it
started.

Before I start describing the problem I thought I should mention that
it sat for 4 years without being run.
So when I got it, I took the tank to a local shop and had it acid
etched and coated.  I also took the carbs off, cleaned them out and
put it all back together.  It ran great for a week, then I let sit.
The next tiime I went to start it, I realized the petcock was clogged
and the shop missed a spot on the tank.  I took it back and had it
recoated.

I took the carbs back of, cleaned them real good and put a new fuel
filter on.  Now I just can't seem to get it started.

When I go to start it, I twist the throttle a couple of times, set the
choke and crank.  It fires for a second or two, then dies.  Never
staying running.  I can never give it any "throttle" to keep it
running.

A couple of things I was wondering:
1.  Should I be tightening the either the small jets or the needle
valves from the air diagphrams above hand tight with a screwdriver?
Or should I leave them a little loose?  I wasn't sure if I am cutting
off the fuel by tightening them.
2.  What are the small teardrop adjusting nobs under the carbs?  There
is one for each carb except the far left carb near the petcock.

Any help is greatly appreciated.

Andrew

--~--~---------~--~----~------------~-------~--~----~
You received this message because you are subscribed to the Google Groups 
"Nighthawk Motorcycle Lovers!" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to 
[email protected]
For more options, visit this group at 
http://groups.google.com/group/nighthawk_lovers?hl=en
-~----------~----~----~----~------~----~------~--~---

Reply via email to