Well, I am by no means a carburetor expert, so you should double check anything I tell you on the subject. But I believe those set screws should be tightened until barely snug, then backed out 2 5/8 turns to set them. The ones with the teardrop I'm told are set at the factory and there shouldn't be any reason to move them. Again, I'd wait until one of the guys on this list with a much better understanding of carbs to 2nd my advice before you follow it ;)
-Kyle On Sat, Dec 13, 2008 at 5:17 PM, Andrew <[email protected]> wrote: > > Hi I have an 83 Nighthawk and I am having a problem getting it > started. > > Before I start describing the problem I thought I should mention that > it sat for 4 years without being run. > So when I got it, I took the tank to a local shop and had it acid > etched and coated. I also took the carbs off, cleaned them out and > put it all back together. It ran great for a week, then I let sit. > The next tiime I went to start it, I realized the petcock was clogged > and the shop missed a spot on the tank. I took it back and had it > recoated. > > I took the carbs back of, cleaned them real good and put a new fuel > filter on. Now I just can't seem to get it started. > > When I go to start it, I twist the throttle a couple of times, set the > choke and crank. It fires for a second or two, then dies. Never > staying running. I can never give it any "throttle" to keep it > running. > > A couple of things I was wondering: > 1. Should I be tightening the either the small jets or the needle > valves from the air diagphrams above hand tight with a screwdriver? > Or should I leave them a little loose? I wasn't sure if I am cutting > off the fuel by tightening them. > 2. What are the small teardrop adjusting nobs under the carbs? There > is one for each carb except the far left carb near the petcock. > > Any help is greatly appreciated. > > Andrew > > > > --~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed to the Google Groups "Nighthawk Motorcycle Lovers!" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/nighthawk_lovers?hl=en -~----------~----~----~----~------~----~------~--~---
