You all got it wrong!  Some idiotic drongo forgot to screw the low speed jets 
in, they were just sitting there,  Wait a minute who am I talking about!
Now to figure out why it's not charging.  Whose got a voltage regulator.  I'll 
trade a 650 Nighthawk VR for a 550 VR,  Graham (idiotic drongo)

On Jul 27, 2012, at 11:59 AM, Allen Thomas wrote:

> Sorry forgot about that. I've been working with Mikuni carbs recently ;-)
> 
> On Fri, Jul 27, 2012 at 8:11 AM, Graham Rogers <[email protected]> 
> wrote:
> the floats are plastic and so they can't be adjusted.  It it's the carbs then 
> it's just going to take more work
> 
> On Jul 27, 2012, at 12:36 AM, surfswab wrote:
> 
> > Sorry, but I'm thinkin' carbs, too.  Specially the float valves.  Not
> > the floats themselves, but the valves (the little rubber-tipped brass
> > pieces they control).  Sounds like they are not seating properly, so
> > not shutting off like they're supposed to when there's enuf fuel in
> > the float bowl.
> >
> > Also, have you drained the crankcase vent tube of bypass gas and
> > moisture and made sure there's no residual in the airbox?
> >
> >
> >
> > On Jul 26, 10:29 pm, Graham Rogers <[email protected]> wrote:
> >> I was afraid someone would send me back to the carbs!  Graham
> >>
> >> On Jul 26, 2012, at 7:08 PM, Allen Thomas wrote:
> >>
> >>
> >>
> >>> Floats stuck open? Did you put them in the right direction? Did you set 
> >>> the fuel screws to a common value between all carbs. Sometimes people 
> >>> turn out the screws to compensate for clogged jets. Stuck enrichening 
> >>> plungers? Try starting it with the throttle opened to dry it out.
> >>> Sent via BlackBerry by AT&T
> >>
> >>> -----Original Message-----
> >>> From: Graham Rogers <[email protected]>
> >>> Sender: [email protected]
> >>> Date: Thu, 26 Jul 2012 18:14:58
> >>> To: Nighthawk Lovers<[email protected]>
> >>> Reply-To: [email protected]
> >>> Subject: [Nighthawk Lovers] CB550SC Nighthawk flooding
> >>
> >>> Here's one that's got me scratching my head.  I just started work on a 
> >>> 550 Nighthawk.  I cleaned the carbs before trying to run it although the 
> >>> PO had it running and I was there with him.  Now with the carbs back on 
> >>> it runs on 1 and 4 but #'s 2 & 3 are just flooding.  The gas is going 
> >>> straight out the mufflers.  Seems to have good spark on all 4.  The carbs 
> >>> were relatively clean before I cleaned them.  Compression is excellent.  
> >>> Bike has only done 11k miles.  I have the tank off and am running it 
> >>> through a funnel and hose so it can't be the pet cock.  Any suggestions?  
> >>> Graham
> >>
> >>> --
> >>> You received this message because you are subscribed to the Google Groups 
> >>> "Nighthawk Motorcycle Lovers!" group.
> >>> To post to this group, send email to [email protected].
> >>> To unsubscribe from this group, send email to 
> >>> [email protected].
> >>> For more options, visit this group 
> >>> athttp://groups.google.com/group/nighthawk_lovers?hl=en.
> >>
> >>> --
> >>> You received this message because you are subscribed to the Google Groups 
> >>> "Nighthawk Motorcycle Lovers!" group.
> >>> To post to this group, send email to [email protected].
> >>> To unsubscribe from this group, send email to 
> >>> [email protected].
> >>> For more options, visit this group 
> >>> athttp://groups.google.com/group/nighthawk_lovers?hl=en.
> >
> > --
> > You received this message because you are subscribed to the Google Groups 
> > "Nighthawk Motorcycle Lovers!" group.
> > To post to this group, send email to [email protected].
> > To unsubscribe from this group, send email to 
> > [email protected].
> > For more options, visit this group at 
> > http://groups.google.com/group/nighthawk_lovers?hl=en.
> >
> 
> --
> You received this message because you are subscribed to the Google Groups 
> "Nighthawk Motorcycle Lovers!" group.
> To post to this group, send email to [email protected].
> To unsubscribe from this group, send email to 
> [email protected].
> For more options, visit this group at 
> http://groups.google.com/group/nighthawk_lovers?hl=en.
> 
> 
> 
> -- 
> You received this message because you are subscribed to the Google Groups 
> "Nighthawk Motorcycle Lovers!" group.
> To post to this group, send email to [email protected].
> To unsubscribe from this group, send email to 
> [email protected].
> For more options, visit this group at 
> http://groups.google.com/group/nighthawk_lovers?hl=en.

-- 
You received this message because you are subscribed to the Google Groups 
"Nighthawk Motorcycle Lovers!" group.
To post to this group, send email to [email protected].
To unsubscribe from this group, send email to 
[email protected].
For more options, visit this group at 
http://groups.google.com/group/nighthawk_lovers?hl=en.

Reply via email to