Shut fuel off and pull the sediment bowl on the petcock. See if it has rust in it.
Sent from Yahoo Mail on Android On Tue, Mar 5, 2019 at 6:37 AM, Graham Rogers<[email protected]> wrote: Is it running on all four when it is idling at 3k, full choke? If not isolate the one cylinder ( I suspect) that is not. Is that the one that had the rust residue? On Mon, Mar 4, 2019 at 11:18 PM Holger Selover-Stephan <[email protected]> wrote: Hi all, My post carb clean bliss lasted 40 miles. Back to the before-behavior of needing choke to run, and idling at 3k after the engine warmed up. I guess it could be rust in the tank. There was some reddish residue in one carb, but the others had none. Is there anything else that could cause this behavior: Cold engine, full choke, starts right upWarm engine: needs full choke and idles at 3k-4k. The idle screw I had set to around 1k when the engine was running fine after the carb cleaning. The only other thing I did was adding an inline fuel filter. I could take that out for a test. Thanks! Holger -- You received this message because you are subscribed to the Google Groups "Nighthawk Motorcycle Lovers!" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at https://groups.google.com/group/nighthawk_lovers. For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "Nighthawk Motorcycle Lovers!" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at https://groups.google.com/group/nighthawk_lovers. For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "Nighthawk Motorcycle Lovers!" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at https://groups.google.com/group/nighthawk_lovers. For more options, visit https://groups.google.com/d/optout.
