> on the ppp0 interface is the traffic from the internetwork to 
> your site and vice versa.  That traffic is addressed to you 
> at the 64. or 24. or whatever address.

ACK
 
> Internal network traffic has the 192.168.1.x/24 address.  
> Your gateway/router handles some of that doing the NAT.  But 
> traffic between nodes on that address just flows PAST the 
> ntop host, not through it.

I was not aware of this. Ok
 
> If you want to monitor that traffic, then you need -i eth0, 
> not -i ppp0

Ok, so I use the eth0 device.
But then I don't see a way to *only* display the hosts in MY network.
If I use 'host 192.168.1.31' as filter, I get in 'NetworkTraffic: Data
Received' 
192.168.1.31 (this is what I want)
[website1] (this is what I don't want)
[website2] (..)
[website3] (..)
[Router]   (..)

I really can't think of a way not to display these. Could you give me a
hint?

Hendrik

_______________________________________________
Ntop mailing list
[EMAIL PROTECTED]
http://lists.ntop.org/mailman/listinfo/ntop

Reply via email to