[Please don't drop the list, responses here can be help to someone else] You can find the install from source instructions at https://github.com/OPENNETWORKINGLAB/flowvisor/wiki/Installation-from-Source.
As you will see under 'Download and Build'; you only need to run 'make' to build it and then follow the instruction on the rest of that page to install it. Hope this helps, -- Ali On Dec 9, 2012, at 2:31 PM, Humphrey Lee <[email protected]> wrote: > Thank you for your quick response, Ali. > > I was trying to build from the source, instead of installing the binary > version. > > I tried to look for instructions to build the source code on the URL you sent > . I could only found the instruction to download the source, but no > instructions to build it. > > To build code successfully as I did for the older version, I think the "git > checkout -b ..." command must be executed. > > I appreciate your help. > > Regards, > Humphrey > > Ali Al-Shabibi 於 2012年12月9日星期日寫道： > (Please don't drop the list) > > To get the latest flowvisor, you should either checkout the master or the > 0.10-MAINT branch. Have a look at > https://github.com/OPENNETWORKINGLAB/flowvisor/wiki for installation > instructions. > > -- > Ali Al-Shabibi > > On Dec 9, 2012, at 9:28, Humphrey Lee <[email protected]> wrote: > >> Hi Ali, >> >> I downloaded version 0.10.0 source by "git clone >> git://github.com/OPENNETWORKINGLAB/flowvisor.git". >> >> I wanted to compile it, but I don't know how to specify this command "git >> checkout -b fv0.4_of1.0 origin/deprecated/of-0.89", as an example found on a >> OpenFlow document. What numbers should I use to replace those fv0.4_of_1.0? >> Please advise. >> >> Thank you. >> >> Cheers, >> Humphrey >> >> On Fri, Dec 7, 2012 at 9:10 PM, Ali Al-Shabibi <[email protected]> >> wrote: >> Hi Humphrey, >> >> The latest version of flowvisor can be obtained from >> http://www.flowvisor.org. Let me know if you need help with the installation. >> >> The FV versions on gitosis are very old and it looks like they are pre-1.0 >> versions. You'll find the latest FV (0.10.0) at flowvisor.org. >> >> >> Cheers. >> >> -- >> Ali >> >> On Dec 7, 2012, at 11:00 AM, Humphrey Lee <[email protected]> wrote: >> >> > Hello Rob, >> > >> > What is the latest version of FlowVisor? Is it 0.8.0. >> > >> > I downloaded and compiled a version from git://gitosis.stanford.edu/, and >> > tried to run it on Netgear GSM7328S. However, I got this error message >> > "tcp:my switch ip-address: 35380: version negotiation failed: we support >> > version 0x97 to. 0x97 inclusive but peer supports no later than 0x01". >> > >> > Does this error message mean my flowvisor version is too old? Does 0x97 >> > mean that I need version 0.97? >> > >> > I appreciate for your help. >> > >> > Sincerely, >> > Humphrey Lee (an OpenFlow developer) >> > >> > >> > _______________________________________________ >> > openflow-discuss mailing list >> > [email protected] >> > https://mailman.stanford.edu/mailman/listinfo/openflow-discuss >> >> _______________________________________________ openflow-discuss mailing list [email protected] https://mailman.stanford.edu/mailman/listinfo/openflow-discuss
