Aggelos Manousidis <[email protected]> wrote: > I had installed about a year ago some version of kamikaze (I think it > was 8.09.1) on the WRT54GL. > I don't recall what settings I had set, like the IP address/port the > web > interface would listen on. <SNIP/> > So my question is, how can I recover from that situation?
Here is what I do when mass flashing WRT54GLs: 1. Turn it off 2. Set your IP computer address to 192.168.1.3 (mask 255.255.255.0) 3. Turn it back on 4. As soon as the DMZ light comes on, press and hold either the "Secure Easy Setup" button or the Reset button until the DMZ light starts to blink 5. Telnet to 192.168.1.1 6a. If you dont care about keeping the existing config, run the "firstboot" command (without the quotes) then reboot 6b. If you want to keep the config, see http://wiki.openwrt.org/doc/howto/generic.failsafe#in.failsafe.mode for how to unlock the config files Aaron Z _______________________________________________ openwrt-users mailing list [email protected] https://lists.openwrt.org/mailman/listinfo/openwrt-users
