on 03/22/2012 04:07 PM Aaron Z wrote the following: > Aggelos Manousidis <[email protected]> wrote: >> BTW WRT54GL is v 1.1 >> I tried all 5 ports (4 + 1 WAN), the link comes up as shown with >> ethtool >> (100 Mb/s Full Duplex), but neither telnet nor ping gets something >> from >> the WRT54GL. >> Telnet says "No route to host" >> Ping says "Destination Host Unreachable" >> and arp -a shows >> ? (192.168.1.1) <incomplete> on eth0 >> On the WRT54GL both Power and DMZ leds blink and the led for each >> port where I connect the UTP cable goes on. >> Any other way to recover? > What is your IP address and netmask?
# ifconfig eth0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500 metric 1 inet 192.168.1.100 netmask 255.255.255.0 broadcast 192.168.1.255 > There is a serial interface on the board, but I would try another computer > first. Seems like something is misbehaving on that one. > See: http://wiki.openwrt.org/toh/linksys/wrt54g#serial.port for the serial > info. Note that you MUST use an adapter to drop the voltage from the 12v that > your computer serial port provides to the 3.3V that the onboard serial port > expects or you WILL let out the magic smoke. > I see ... Is there any other method, like tftp a new image file or something? _______________________________________________ openwrt-users mailing list [email protected] https://lists.openwrt.org/mailman/listinfo/openwrt-users
