This one has me stumped. I have an Adaptec 2940UW with 1 80 pin hard disk attached via 80 pin/68/50 pin converter. I can't get this to complete initialization from FWB (Unknown HDT error), or Drive Setup (Initialization failed).
I have an active terminator on the end of the 68 pin cable. If I hook it to the 50 pin port on either the motherboard or the 2940UW, it works fine. The 68 pin connector was working fine, until I removed all my RAM and replaced it with new RAM, 12 x 32 MB = 384 (it had 192 MB), all matched. Sometime near when I did this, it stopped being reliable. Can the RAM cause this? I can't imagine... Any ideas will be greatly appreciated! --> Russ -- PCI-PowerMacs is sponsored by <http://lowendmac.com/> and... Small Dog Electronics http://www.smalldog.com | Refurbished Drives | -- Sonnet & PowerLogix Upgrades - start at $169 | & CDRWs on Sale! | Support Low End Mac <http://lowendmac.com/lists/support.html> PCI-PowerMacs list info: <http://lowendmac.com/lists/pci-powermacs.shtml> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive:<http://www.mail-archive.com/pci-powermacs%40mail.maclaunch.com/> Using a Mac? Free email & more at Applelinks! http://www.applelinks.com
