Jaume, accidentally I removed the read-only lock slider from one of my
cards. It is mere piece of material that occupies specific 3d location
(for lack of better words). My cameras and reader had hard time working
with this card. When I attached a little piece of scotch tape in place
where this piece of plastic was, the card worked fine.
HTH.
Boris
. On 3/27/2010 10:38 PM, Jaume Lahuerta wrote:
Hi,
My uncle's point&shot has been crushed by a vehicle. There is nothing to do
with it but since I have had no problem taking the card out of the rests of the
camera, and the card seemed fine externally, I was sure that the pictures were
going to be fine (and that's what I told him).
This has not been the case. Two card readers do not read anything, my K20D says
'card error' and my Optio W20 refuses to power on with this card inside...
Do you think that there is any hope with this card?
Thanks,
Jaume
--
PDML Pentax-Discuss Mail List
[email protected]
http://pdml.net/mailman/listinfo/pdml_pdml.net
to UNSUBSCRIBE from the PDML, please visit the link directly above and follow
the directions.
