I agree with you, Peter. But in order to recover the files on the card,
this could be sufficient.
On 3/28/2010 7:38 PM, P. J. Alling wrote:
That's the solution I used with the *ist-Ds the K20d however has tighter
tolerances and won;t accept a card with tape on it. Also the tape is
eventually unable to hold out to the pressure from the sensor and needs
to be replaced. I wouldn't trust it in a critical situation. I never
know when that fix is going to fail.
On 3/28/2010 9:17 AM, Boris Liberman wrote:
Jaume, accidentally I removed the read-only lock slider from one of my
cards. It is mere piece of material that occupies specific 3d location
(for lack of better words). My cameras and reader had hard time
working with this card. When I attached a little piece of scotch tape
in place where this piece of plastic was, the card worked fine.
HTH.
Boris
. On 3/27/2010 10:38 PM, Jaume Lahuerta wrote:
Hi,
My uncle's point&shot has been crushed by a vehicle. There is nothing
to do with it but since I have had no problem taking the card out of
the rests of the camera, and the card seemed fine externally, I was
sure that the pictures were going to be fine (and that's what I told
him).
This has not been the case. Two card readers do not read anything, my
K20D says 'card error' and my Optio W20 refuses to power on with this
card inside...
Do you think that there is any hope with this card?
Thanks,
Jaume
--
PDML Pentax-Discuss Mail List
[email protected]
http://pdml.net/mailman/listinfo/pdml_pdml.net
to UNSUBSCRIBE from the PDML, please visit the link directly above and follow
the directions.
