Bill- The rewind crank? Are you saying that I pull hard on the U shaped bit and the crank comes out from the top? Should I use anything to lube the shaft before reassembly, like a Teflon dry lube?
Taka -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] On Behalf Of Bill D. Casselberry Sent: Thursday, May 30, 2002 9:36 PM To: [EMAIL PROTECTED] Subject: Re: Motor Drive problems TM wrote: > Does this sound like my Super A needs a CLA, or does it still point to > the Motor Drive causing problems? The Super Series can gett friction hang-up in the shaft/sleeve of the rewind crank. Mine has, but its easy fix. You just take out the rewind crank and clean/buff out the shaft and sleeve. Ya just need to hold the U end of the shaft firm to get the thing apart. It's not a whole lot of resistance, but winders don't like it. Got the tip from a list member (forget who - an oldtimer I think gone now) a few years ago. ... worth a try. Bill --------------------------------------------------------- Bill D. Casselberry ; Photography on the Oregon Coast http://www.orednet.org/~bcasselb [EMAIL PROTECTED] --------------------------------------------------------- - This message is from the Pentax-Discuss Mail List. To unsubscribe, go to http://www.pdml.net and follow the directions. Don't forget to visit the Pentax Users' Gallery at http://pug.komkon.org . - This message is from the Pentax-Discuss Mail List. To unsubscribe, go to http://www.pdml.net and follow the directions. Don't forget to visit the Pentax Users' Gallery at http://pug.komkon.org .
