TM wrote:
> The rewind crank? Are you saying that I pull hard on the U shaped
> bit and the crank comes out from the top? Should I use anything to
> lube the shaft before reassembly, like a Teflon dry lube?
No - hold it w/ a flatblade screwdriver, then the top screws
off counterclockwise. That non-oily electrical cleaner spray
stuff was what was suggested to me. The teflon dry lube might
work - idea is not to have gunk-collection in there from what-
ever you use. My winderII would "jam/stall" quite often until
I did this clean-up.
Bill
---------------------------------------------------------
Bill D. Casselberry ; Photography on the Oregon Coast
http://www.orednet.org/~bcasselb
[EMAIL PROTECTED]
---------------------------------------------------------
-
This message is from the Pentax-Discuss Mail List. To unsubscribe,
go to http://www.pdml.net and follow the directions. Don't forget to
visit the Pentax Users' Gallery at http://pug.komkon.org .
