Even the database I opened just before the problem occurred proved not to be a/the problem.
But after using Camtastic the problem re-appeared..... No other programs (apart from email) used in between, so the culprit must be Camtastic.
This leads to the 'good news-bad news' bit: the good news is that my system works again. The bad news: I'm stuck with more questions than before.
Why does Camtastic (3.0.4, shipped with P99SE) mess up my Protel installation (more specific: the PCB part)?
How do I prevent that? I need Camtastic to examine/modify my Gerbers; or can anyone reccommend an alternative with roughly the same functionality?
Still, any input is greatly appreceated.
Leo Potjewijd hardware designer Integrated Engineering B.V.
[EMAIL PROTECTED] +31 20 4620700
____________________________________________________________ You are subscribed to the PEDA discussion forum
To Post messages: mailto:[EMAIL PROTECTED]
Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
