Igor,
The analyzing GND problem is not part of a DRC check. It is some sort
of internal checking process, there is no option to hit ESC and stop the
process. You can sit and wait while it is analyzing GND for 30 - 45 minutes, no
problem.
Better advice, why pour polygons that are not going to actually be
poured, just don't pour polygons until your routing is complete or almost
complete?
Sincerely,
Brad Velander
Senior PCB Designer
Northern Airborne Technology
1925 Kirschner Rd.,
Kelowna, BC, V1Y 4N7.
tel (250) 763-2329 ext. 225
fax (250) 762-3374
-----Original Message-----
From: M P [mailto:[EMAIL PROTECTED]
Sent: Thursday, March 03, 2005 4:36 PM
To: [email protected]
Subject: RE: [PEDA] Analysing ground on large Polygon Pours.
Wouldn't it cancel DRC when you press 'ESC' key during the DRC check. It
needs a while to stop the process, especially if the polygons are large, but
it does it eventually.
Another good advice, coming from this forum, is to set the polygon track
width to a large value while you are laying out the tracks, so that polygons
are not poured. Change the polygon track width back to your preferred value
once you finished with tracks and DRC will check it only once, saving you a
lot of time.
Igor
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
