Count me lucky or what, LF is not a concern to us? Reportedly (I have not seen anything in writing that grants that exemption but others swear to it) we are exempt as avionic equipment.
Sincerely, Brad Velander Senior PCB Designer Northern Airborne Technology #14 - 1925 Kirschner Road, Kelowna, BC, V1Y 4N7. tel (250) 763-2329 ext. 225 fax (250) 762-3374 -----Original Message----- From: Mira [mailto:[EMAIL PROTECTED] Sent: Thursday, December 08, 2005 10:10 AM To: Protel EDA Discussion List Subject: Re: [PEDA] Via Solder Thieving, heard of this? Due to these problems BGAs are the only parts that will remain leaded even on a PB-free board. Mira --- Dennis Saputelli <[EMAIL PROTECTED]> wrote: > that is a good point > in fact i have been wondering about how to clean > under these things, it > has been my understanding that for BGAs the > preferred process is > no-clean because water is 'too big' and solvent is a > no-no > again, how does all this relate to lead-free ? > i think LF needs a more aggressive flux, correct ? > > ds ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
