Thanks Jeff, I have to go and try and make some money for a few hours, I'll try that as soon as I return.
Again, thanks for the help, Mark -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of Jeff Fleitz Sent: Friday, February 11, 2005 10:08 AM To: [email protected] Subject: Re: [plum] setting a data source Oh, you will need to stop and restart the service for the changes to take effect... Jeff Mark Fuqua wrote: > Thanks Jeff, that is one of the first things I did when trouble shooting > yesterday. It was in ColdFusion Documentation...I did just check again and > it is checked. On that same tab, on the bottom, there is a choice that > says: > > "Start and run SQL server in the following account" the check boxes are: > "system account" and "this account" > > Currently, system account is checked. Is that the correct choice? > > Thanks, > > Mark > > > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] Behalf Of Jeff > Fleitz > Sent: Friday, February 11, 2005 8:51 AM > To: [email protected] > Subject: Re: [plum] setting a data source > > > Try making sure that you are using a user account/password (mixed mode) and > not a trusted connection when you get to > that point. > > > Jeff > > > > Mark Fuqua wrote: > >>I am ashamed to say that I have been working on this all night and still > > can > >>not figure it out. I could not get a data source set up using Microsoft > > SQL > >>Server Driver in mx7. >> >>I tried it many different ways and got many different error messages. >>Finally in desperation, I went to the macromedia forums and found this >>topic: >> >> > > http://www.macromedia.com/cfusion/webforums/forum/messageview.cfm?catid=6&th > >>readid=958596&enterthread=y >> >>It seemed I was not alone in the universe. I followed the instructions > > and > >>the connection worked. It tested fine when I set it up in "data sources" > > in > >>administrative tools in my control panel and it tested fine in ColdFusion >>administrator. However, when I went to return to Plum I got the following >>error: "The ColdFusion data source you specified doesn't work. Click > > back, > >>correct the ColdFusion data source and click next to try again." >> >>The data source checks ok in ColdFusion. Any clues? >> >>thanks for your time, >> >>Mark Fuqua >> >> >> >> >> >>********************************************************************** >>You can subscribe to and unsubscribe from lists, and you can change >>your subscriptions between normal and digest modes here: >> >>http://www.productivityenhancement.com/support/DiscussionListsForm.cfm >>********************************************************************** >> >> > > > ********************************************************************** > You can subscribe to and unsubscribe from lists, and you can change > your subscriptions between normal and digest modes here: > > http://www.productivityenhancement.com/support/DiscussionListsForm.cfm > ********************************************************************** > > > > ********************************************************************** > You can subscribe to and unsubscribe from lists, and you can change > your subscriptions between normal and digest modes here: > > http://www.productivityenhancement.com/support/DiscussionListsForm.cfm > ********************************************************************** > > ********************************************************************** You can subscribe to and unsubscribe from lists, and you can change your subscriptions between normal and digest modes here: http://www.productivityenhancement.com/support/DiscussionListsForm.cfm ********************************************************************** ********************************************************************** You can subscribe to and unsubscribe from lists, and you can change your subscriptions between normal and digest modes here: http://www.productivityenhancement.com/support/DiscussionListsForm.cfm **********************************************************************
