That should be fine. Thanks for your assistance in helping me isolate the problem.
Dave ----- Original Message ----- From: "Mark Fuqua" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Friday, February 11, 2005 11:03 AM Subject: RE: [plum] setting a data source > Thanks Dave, > > I have to run to a customer's house. Should be back by 1:00. will call > then. You must have a ton of stuff to do today after being out all week. > Thanks for taking the time to respond. > > Mark Fuqua. > > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] Behalf Of David > Churvis > Sent: Friday, February 11, 2005 10:42 AM > To: [email protected] > Subject: Re: [plum] setting a data source > > > Mark, > > Can you give me a call before 2:00 today so I can find out more about your > problem? > > Thanks, > Dave > ----- Original Message ----- > From: "Mark Fuqua" <[EMAIL PROTECTED]> > To: <[email protected]> > Sent: Friday, February 11, 2005 12:38 AM > Subject: [plum] setting a data source > > > > I am ashamed to say that I have been working on this all night and still > can > > not figure it out. I could not get a data source set up using Microsoft > SQL > > Server Driver in mx7. > > > > I tried it many different ways and got many different error messages. > > Finally in desperation, I went to the macromedia forums and found this > > topic: > > > > > http://www.macromedia.com/cfusion/webforums/forum/messageview.cfm?catid=6&th > > readid=958596&enterthread=y > > > > It seemed I was not alone in the universe. I followed the instructions > and > > the connection worked. It tested fine when I set it up in "data sources" > in > > administrative tools in my control panel and it tested fine in ColdFusion > > administrator. However, when I went to return to Plum I got the following > > error: "The ColdFusion data source you specified doesn't work. Click > back, > > correct the ColdFusion data source and click next to try again." > > > > The data source checks ok in ColdFusion. Any clues? > > > > thanks for your time, > > > > Mark Fuqua > > > > > > > > > > > > ********************************************************************** > > You can subscribe to and unsubscribe from lists, and you can change > > your subscriptions between normal and digest modes here: > > > > http://www.productivityenhancement.com/support/DiscussionListsForm.cfm > > ********************************************************************** > > > > > ********************************************************************** > You can subscribe to and unsubscribe from lists, and you can change > your subscriptions between normal and digest modes here: > > http://www.productivityenhancement.com/support/DiscussionListsForm.cfm > ********************************************************************** > > > > ********************************************************************** > You can subscribe to and unsubscribe from lists, and you can change > your subscriptions between normal and digest modes here: > > http://www.productivityenhancement.com/support/DiscussionListsForm.cfm > ********************************************************************** > ********************************************************************** You can subscribe to and unsubscribe from lists, and you can change your subscriptions between normal and digest modes here: http://www.productivityenhancement.com/support/DiscussionListsForm.cfm **********************************************************************
