Mark, Can you give me a call before 2:00 today so I can find out more about your problem?
Thanks, Dave ----- Original Message ----- From: "Mark Fuqua" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Friday, February 11, 2005 12:38 AM Subject: [plum] setting a data source > I am ashamed to say that I have been working on this all night and still can > not figure it out. I could not get a data source set up using Microsoft SQL > Server Driver in mx7. > > I tried it many different ways and got many different error messages. > Finally in desperation, I went to the macromedia forums and found this > topic: > > http://www.macromedia.com/cfusion/webforums/forum/messageview.cfm?catid=6&th > readid=958596&enterthread=y > > It seemed I was not alone in the universe. I followed the instructions and > the connection worked. It tested fine when I set it up in "data sources" in > administrative tools in my control panel and it tested fine in ColdFusion > administrator. However, when I went to return to Plum I got the following > error: "The ColdFusion data source you specified doesn't work. Click back, > correct the ColdFusion data source and click next to try again." > > The data source checks ok in ColdFusion. Any clues? > > thanks for your time, > > Mark Fuqua > > > > > > ********************************************************************** > You can subscribe to and unsubscribe from lists, and you can change > your subscriptions between normal and digest modes here: > > http://www.productivityenhancement.com/support/DiscussionListsForm.cfm > ********************************************************************** > ********************************************************************** You can subscribe to and unsubscribe from lists, and you can change your subscriptions between normal and digest modes here: http://www.productivityenhancement.com/support/DiscussionListsForm.cfm **********************************************************************
