Hi, I currently have my PowerPro bar at the top of my screen, full size. Most of the time I've had the '3d frame' option under the config checked. This was because if I didn't, the icons on the bar itself had a little bit of their tops cut off. However, I have turned that option off now, as when it is on, you can hold your mouse over the edge of the bar and drag to size it. I was resizing it down to 0 pixels accidentally too often, so I had to switch the option off. Now however, I have the tops of the icons cut off. Is there any way to have both that option off, and at the same time, correct the position of the icons? See http://www.users.on.net/~romulous/PPro- 1.jpg for what my bar looks like with the option off (you can see the tops of the icons just cut off), and see http://www.users.on.net/~romulous/PPro-2.jpg for the option on (you can see the difference in the pics - with the option on, the icons are further down the bar, which means no cut tops, and also have less of a blank gap at the bottom).
Regards, CM ------------------------ Yahoo! Groups Sponsor --------------------~--> Get fast access to your favorite Yahoo! Groups. Make Yahoo! your home page http://us.click.yahoo.com/dpRU5A/wUILAA/yQLSAA/JV_rlB/TM --------------------------------------------------------------------~-> Attention: PowerPro's Web site has moved: http://www.ppro.org Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/power-pro/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
