The "parameters" you listed are just names of controlled sources. That can
not be the problem. The analog devices models look ok, they are pure spice
and should work. There must be something else what makes your simulations
fail. What about your windows default decimal separator ? European
installations use the "comma",  protel needs the "dot". Why did you fetch
the model from analog because they are supplied directly from protel with
their analog devices library ?

i2e / R.Molitor

-----Urspr ngliche Nachricht-----
Von: Thomas Ebert <[EMAIL PROTECTED]>
An: Multiple recipients of list proteledausers
<[EMAIL PROTECTED]>
Gesendet: Mittwoch, 7. Februar 2001 09:48
Betreff: [PROTEL EDA USERS]: Q:Adding Spice Models


> Hi folks,
>
> for a test cicuit I need to simulate a OP284 from AD. So I fetched
> the spice model from AD, dropped the file into ..\SIM\Analog Devices\
> and tried to start a transient simulation.
> The simulation failed because some of the parameters in the new
> model are unknown to the Protel simulator.
> The parameters are like "gn", "e", "enz", ...
> As you can see I am not very familiar with spice simulations but
> the same error appears if I try to simulate other "new" models.
> As long as I use Protel`s simulation models, everything works fine.
>
> Does someone know how to overcome this ?
>
> Cheers, Tom
> e-mail: [EMAIL PROTECTED]
>
>
>
>
>
> * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
> *  This message sent by: PROTEL EDA USERS MAILING LIST
> *
> *  Use the "reply" command in your email program to
> *  respond to this message.
> *
> *  To unsubscribe from this mailing list use the form at
> *  the Association web site. You will need to give the same
> *  email address you originally used to subscribe (do not
> *  give an alias unless it was used to subscribe).
> *
> *  Visit http://www.techservinc.com/protelusers/subscrib.html
> *  to unsubscribe or to subscribe a new email address.
> * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *



* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
*  This message sent by: PROTEL EDA USERS MAILING LIST
*
*  Use the "reply" command in your email program to
*  respond to this message.
*
*  To unsubscribe from this mailing list use the form at
*  the Association web site. You will need to give the same
*  email address you originally used to subscribe (do not
*  give an alias unless it was used to subscribe).
*
*  Visit http://www.techservinc.com/protelusers/subscrib.html
*  to unsubscribe or to subscribe a new email address.
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

________________________________________________________

To leave the EDAFORUM discussion list, send a email with
'leave edaforum' in the body to '[EMAIL PROTECTED]'

More Information : http://www.dolist.net

Reply via email to