At 11:15 AM 2/7/01 -0800, you wrote:
>I also need to do these translations. Currently I am trying to get from
>Orcad Capture 7.2 to Protel 99 SE. That is from an Orcad schematic to Protel
>layout. I am not interested in bring the schematic into Protel, only the
>netlist. I have tried various Orcad netlisters with no success. It could be
>that I am not using the proper extension to the file so Protel does not
>recognize it. Any suggestions?

Use the Tango format. The schematic can be imported to Protel if you want, 
however.


[EMAIL PROTECTED]
Abdulrahman Lomax
P.O. Box 690
El Verano, CA 95433



* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
*  This message sent by: PROTEL EDA USERS MAILING LIST
*
*  Use the "reply" command in your email program to
*  respond to this message.
*
*  To unsubscribe from this mailing list use the form at
*  the Association web site. You will need to give the same
*  email address you originally used to subscribe (do not
*  give an alias unless it was used to subscribe).
*
*  Visit http://www.techservinc.com/protelusers/subscrib.html
*  to unsubscribe or to subscribe a new email address.
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

________________________________________________________

To leave the EDAFORUM discussion list, send a email with
'leave edaforum' in the body to '[EMAIL PROTECTED]'

More Information : http://www.dolist.net

Reply via email to